The Spitronics DB1 Positive Diode Board is designed to provide the freewheel diode arrangement required when using compatible positive drivers to control inductive loads. These diodes are particularly important when controlling PWM solenoids or other low-resistance inductive loads.
Because Spitronics control systems can be used for either engine or transmission management, the required freewheel diodes may need to be installed in the wiring harness when using a Level 1 harness or manufacturing a custom harness.
Key Features
- Positive-driver configuration: Designed for compatible positive-driver applications.
- Inductive load protection: Provides the required freewheel diode arrangement for suitable inductive loads.
- PWM solenoid compatibility: Suitable for applicable PWM-controlled solenoid installations.
- Compact design: Can be incorporated directly into the wiring harness.
- Flexible installation: Supports custom harness construction and compatible Level 1 harness installations.
Installation Notes
The DB1 board must be wired according to the supplied Spitronics installation diagram, with the diode orientation and connections appropriate for positive drivers. The R2+ connection must be connected to a negative wire, as specified in the product documentation.
Where possible, make the connections inside the vehicle to protect the board from environmental exposure. If installed outside the vehicle, seal the board against moisture and dirt. The supplied documentation recommends applying silicone before fitting heat-shrink sleeving to help seal the components.
Important: Always use the correct diode board for the driver configuration. Incorrect board selection or diode orientation can short the drivers and damage the TCU. Ensure that all wiring connections are insulated and free of short circuits.
Refer to the official Spitronics DB1 Positive Drivers documentation for the wiring diagrams and diode orientation.
